Home > News > Content

The Problem Of Easy To Overlook When Buying A Bending Machine

In the purchase of bending machine, people tend to ignore the material in the bending machine before the bending side of the long side.

Assuming a 90 ° bend along a 5 x 10 foot 10-gauge low carbon steel plate, the bending machine probably has to apply an additional 7.5 tons of pressure to lift the steel plate, and the operator must prepare for a 280-pound straight edge The The manufacture of the part may require several strong workers and even a crane.

Bending machine operators often need to bend the long side parts, but do not know how hard they work hard. There is now a feeder device suitable for the work of this workshop, this device can be based on the needs of new and old machines to be improved. With this device, forming a long side part requires only one person to operate.

The structure of the bending machine:

1, the slider part: the use of hydraulic transmission, slider part of the slider, cylinder and mechanical block fine structure. The left and right cylinders are fixed on the frame, and the piston (rod) is driven by the hydraulic pressure to move the slider up and down. The mechanical stop is controlled by the numerical control system.

2, the table part: by the button box manipulation, so that the motor drive block forward and backward movement, and control by the NC system to move the distance, the minimum reading of 0.01 mm (front and rear position are limit switch limit);

3, the synchronization system: the machine by the torsion axis, swing arm, joint bearings and other mechanical synchronization mechanism, simple structure, stable and reliable performance, high precision synchronization. Mechanical stop by the motor regulation, numerical control system control values;

4, the block body: block the use of motor drive, driven by chain drive two screw synchronous movement, CNC system control block size.